iPhone links:

http://iphone-bulgaria.com/forum/
http://iphone-bulgaria.com/forum/viewtopic.php?f=17&t=23824

http://iphone-bulgaria.com/forum/viewtopic.php?f=17&t=11965

http://www.iphone-bulgaria.com/forum/viewtopic.php?f=17&t=25150

http://iphone-bulgaria.com/forum/viewtopic.php?f=25&t=7015&p=193768&hilit=appleid#p193768

http://iphone-bulgaria.com/forum/viewtopic.php?f=11&t=3531

http://android.modaco.com/content/lg-gt540-optimus-gt540-modaco-com/315433/tutorial-getting-the-gt540-working-with-lg-pc-suite/

Note that you should turn off Settings->SD card -> Mass Storage Only option.

Cheers.

Step #2: We need to connect the BlackBerry to the Computer via USB cable. But here’s where the tricky part comes in with the Nuked BlackBerry. Do you see in the image above where it says COM1? What we want to do is plug in the BlackBerry, and when COM1 switches to say USB-PIN:UNKNOWN we immediately click Next. This catches the BlackBerry and takes it out of the constant reboot cycle and allows you to then reload the Operating System.

Tip: The USB-PIN:UNKNOWN option will display for a few seconds when the BlackBerry is first connected/flashing its LED in red. With a Nuked BlackBerry,  That occurs when the device is in the initial start-up part of it’s reboot sequence. The easiest way to get that to happen (vs. waiting for that step in the reboot sequence where you have a tenth of a second to hit Next before you lose your chance) is to simply pull the battery from the BlackBerry. With the battery pulled, connect the BlackBerry to the USB connector and as SOON as you see USB-PIN:UNKNOWN hit Next. You have to be quick still, but using this method you are in control of the timing. From there you can put the battery back in and battery cover back on (Make Sure you install the battery or else when the OS update is completing and the device disconnects from the computer to reboot, it will lose the power provided by the USB connection and you will get an error and have to do it all over again!).

** If you don’t get it right the first time, try again (unplug from USB, pull battery, connect and hit Next while USB-PIN:Unknown is showing). You have to be fast and the timing is key, so it may take you three or four tries.

&
command1 & command2
Execute Command1 and then execute Command2

&&
command1 && command2
Runs the command2 only when command1 does Complete successfully

||
command1 || command2
Runs the second command if the first command had an error

()
(command1 || command2) || (command3 & command4)
Defines the order in which commands are to be executed

More Info .. Copied From “ntcmds.chm” Present In “%SystemRoot%\Help”
>
Writes the command output to a file or a device, such as a printer, instead of the Command Prompt window.
<
Reads the command input from a file, instead of reading input from the keyboard.
>>
Appends the command output to the end of a file without deleting the information that is already in the file.

>&
Writes the output from one handle to the input of another handle.
<&
Reads the input from one handle and writes it to the output of another handle.

|
Reads the output from one command and writes it to the input of another command. Also known as a pipe.

this is a test caption

http://hv-designs.co.uk/2009/07/31/portfolio-layout-11/

Opened file
Start recording
Operation1, Operation2, … , OperationN
Close file
Stop recording

Note that when exporting file there is a useful option to “overwrite default save”.

C:\Windows\system32>powercfg /hibernate on